The other day I was monkeying around with 3D settings in the options of MEP and probably (more than probably) changed something. But here's my problem and it's never happened before. I'm kinda old school I guess, when I need to make a 3D part for a block or MVPart or whatever, I've always extruded a square or rectangle. Yesterday I extruded a rectangle and suddenly I can't make it solid. It's open on the ends that I extruded from and the opposite end. There were just four solid sides instead of six. I've tried to unmonkey the settings with no luck, and don't know what is the defaults are.
I'd appreciate any advice someone may have other than "Leave the settings alone"...
Thanks.
Kevin...