Window cutting thickness out of extruded wall

[spicedink]

I have a client using shipping containers & I have created the wall using an extrusion. However when I insert the window Revit doesn't cut the entire wall thickness (depth).
The opening cut seems to take the thickness of 1 plane only.
Can you adjust the thickness of the opening cut in the window family? scrap.jpg

Spice

[PijPiwo]

Can you adjust the thickness of the opening cut in the window family?

No, you cannot, but you can replace an opening cut with a void to control the depth of the cut in the project.


Is your corrugated wall a single wall? Is your window an OOTB family, was it modify in any way? If you could upload your wall with the window, it would be easier to troubleshoot.

[spicedink]

Thanks a mil PijPiwo
The void extrusion worked perfectly.
Spice