attached is a view of wall.
There are ducts on the other side of the wall, and the duct center cross-hairs show through the wall.
Why that? and how to stop it. I don't use the MEP stuff at all so it's all new to me.
|
|
|
attached is a view of wall.
There are ducts on the other side of the wall, and the duct center cross-hairs show through the wall.
Why that? and how to stop it. I don't use the MEP stuff at all so it's all new to me.
Can you pull the view depth back so it's not that deep?
Just a thought.
Actually no, there are some elements in the larger drawing that are back 30 or 40 feet behind this wall.
Is this a 'normal behavior' for Revit?
I've run into it before and I think I fixed it by adjusting the view depth and changing the Cut type to Cut without line or something like that.
I know I've run into it, I just can't remember how I fixed it.
I tried all 3 far depth clipping options around, no help.
Are you sure they don't penetrate the wall, even by the tiniest fraction of an inch?