Results 1 to 1 of 1

Thread: mesh on my slab

  1. #1
    Member
    Join Date
    2016-01
    Location
    Lithuania
    Posts
    23
    Login to Give a bone
    0

    Default mesh on my slab

    hi,

    I am lost a bit. I have simple slab supported on beams. I make three different meshes.
    First - default with 1 meter mesh. Second same, but 0,5 meter mesh. Third - comlex mesh, refinement Delauney+Kang and emitters over columns.

    I switch on Reduce moments over columns and Mxx bending moments. Results differ a lot. How should I decide which one is ok?

    mesh.PNG
    Mx with reduction above columns.PNG

    any help appreciated
    Last edited by valensa; 2016-01-27 at 08:53 AM.

Similar Threads

  1. Replies: 0
    Last Post: 2013-12-31, 01:42 PM
  2. Convert MESH to legacy POLYFACE MESH object
    By PytorOuspensky in forum AutoLISP
    Replies: 0
    Last Post: 2013-06-26, 02:04 AM
  3. FLATT SLAB MODELLERS - What Are Your Preferred Mesh Options
    By dconnolly128422 in forum Robot Structural Analysis
    Replies: 0
    Last Post: 2011-07-28, 09:01 AM
  4. Ribbed Slab: Beam system borders inside slab
    By smm.144 in forum Revit Structure - General
    Replies: 6
    Last Post: 2010-09-13, 10:52 AM
  5. Floor Slab Edge host sweep type on a sloped slab
    By gravelin in forum Revit Architecture - General
    Replies: 2
    Last Post: 2005-02-17, 07:47 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •