Results 1 to 4 of 4

Thread: query in contours

  1. #1
    All AUGI, all the time
    Join Date
    2004-06
    Location
    Slidell, Louisiana
    Posts
    968
    Login to Give a bone
    0

    Default query in contours

    I'm have a dwg with an image (MrSid) inserted using the mapiinsert command. I created a surface using a DEM file, extracted the contour information which gives me plines with elevations.
    Using the planning and analysis workspace, map explorer, i'm trying to query in the contour info over the image file. cannot figure out the procedure or what query to use. anyone have
    any ideas of how to do this.

    thanks.

  2. #2
    I could stop if I wanted to
    Join Date
    2014-08
    Posts
    447
    Login to Give a bone
    0

    Default Re: query in contours

    HI
    Not a quick process check out this site
    https://knowledge.autodesk.com/suppo...-values-s.html

    If you plan on doing much of this I would suggest you look into getting Civil3D book from Cadapult Software one of the best

  3. #3
    Geospatial Moderator Jmurphy's Avatar
    Join Date
    2000-11
    Location
    TN/KY Area
    Posts
    1,640
    Login to Give a bone
    0

    Default Re: query in contours

    In the dwg that you converted the DEM(Surface) to plines with Elevations did you save the dwg then close it? Are the coordinate systems assigned to both dwgs?

  4. #4
    All AUGI, all the time
    Join Date
    2004-06
    Location
    Slidell, Louisiana
    Posts
    968
    Login to Give a bone
    0

    Default Re: query in contours

    yes to both questions. the one caveat is the dem file is in utm83-15 meters and the new file is in louisiana state plane-feet.

    i created a new dwg same coordinated system and units and it queried them in with no problem.

Similar Threads

  1. 2012: Contours from SHP file - Geospatial Query Bdy limits
    By Mdouglas in forum AutoCAD Civil 3D - Surfaces
    Replies: 2
    Last Post: 2013-03-09, 08:26 AM
  2. Doing query through FDO
    By VBOYAJI in forum AutoCAD Map 3D - General
    Replies: 4
    Last Post: 2007-04-20, 09:38 AM
  3. map query's from GIS shapes
    By gisdude in forum AutoCAD Map 3D - General
    Replies: 3
    Last Post: 2006-03-31, 11:02 PM
  4. Fascia query
    By PeterJ in forum Revit Architecture - General
    Replies: 6
    Last Post: 2003-06-05, 09:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •