Complicated Model

[Mandy_Jo]

I am creating a family and I cannot seem to figure out how to get the corner wedges to work. Attached is a plan and a section.

VF Island Plan.JPG

VF Island Section.JPG

As you can see it is a slanted shelf that is wedged shape with a curved end.

Any advice on how to acheive this in the Revit Family?

[marmiketin]

This is a little bit late but this can be accomplished using sweeps and swept blends. The outer edge can be made with a sweep. The section from the first set of interior corners to the center can be made using a swept blend.