So, I've been trying to figure out this family for a while without any luck. I'm creating a concentric vent to show on our walls and for some reason it's showing on top of the wall in plan, even though the elevation is set to 9'-0". The Cut plane in the floor plan is set to 4'-0" and the Top is set at 7'-6". I've attached an image of what it looks like.
Also, a side problem. I've set the origin of the family by creating two reference planes that are set to "Defines origin" (see attached pic). Unfortunately, when I go to place the family in an elevation view, it is being placed by the top-most part of the element, in this case, being the top of symbolic line as opposed to the center of the concentric vent.
Any thoughts?
Thank you in advance!