Results 1 to 4 of 4

Thread: Sheetmetal inside corner won't miter

  1. #1
    Active Member
    Join Date
    2003-11
    Posts
    64
    Login to Give a bone
    0

    Default Sheetmetal inside corner won't miter

    I can't find away to get the corner flange, flange1.jpg, to miter (45 deg) and as the picture shows the "flattened" part flange2.jpg (the overlap doesn't show up but the lack of a joint is obvious) has overlapping flanges. Is there any way to get a miter in this corner.



    flange1.jpg


    flange 2.jpg

  2. #2
    I could stop if I wanted to
    Join Date
    2015-12
    Posts
    293
    Login to Give a bone
    0

    Default Re: Sheetmetal inside corner won't miter

    A true flat pattern cannot be developed for this folded part. If this was an outside corner, the "Tear" option should give you what you want.

  3. #3
    All AUGI, all the time
    Join Date
    2000-12
    Location
    Williamsport, PA
    Posts
    641
    Login to Give a bone
    0

    Default Re: Sheetmetal inside corner won't miter

    This can easily be fixed - attach your *.ipt file here.

  4. #4
    Woo! Hoo! my 1st post
    Join Date
    2014-03
    Location
    Wisconsin, USA
    Posts
    1
    Login to Give a bone
    0

    Default Re: Sheetmetal inside corner won't miter

    JD Mather, wondering if I could see the solution to this as well? My part is a rectangular face with four inside flanges as in attached image "SM (1).png". Obviously, however, the inside corners conflict as in "SM (2).png". I tried unfolding and applying a Corner Seam to each conflicting area as in "SM (3).png", but it keeps failing. Am I thinking of this wrong?SM (1).PNGSM (2).PNGSM (3).PNG

    Thanks for any help!

Similar Threads

  1. inside corner at varing width beams
    By david_peterson in forum Revit Structure - General
    Replies: 10
    Last Post: 2010-04-27, 12:29 PM
  2. Curtainwall - Vertical mullions near corner cause horizontal mullions to not miter
    By Eric Stewart in forum Revit Architecture - General
    Replies: 4
    Last Post: 2010-04-01, 12:56 PM
  3. Sheetmetal gurus, please Help!
    By awarren in forum Inventor - General
    Replies: 0
    Last Post: 2006-06-22, 04:00 PM
  4. Exterior Elevation view - inside corner
    By blumarble in forum Revit Architecture - General
    Replies: 1
    Last Post: 2006-05-12, 07:12 PM
  5. Trouble snapping to wall core inside corner point
    By Rhythmick in forum Revit Architecture - General
    Replies: 3
    Last Post: 2004-11-05, 03:48 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •