Hi All,

I've just recently started using Revit after years of not using Revit and I think I'm picking it up ok (with a LOT of help from this forum).

I have a question about the Stair Tread Annotation, is there a way of stopping the annotation above the cut line of the stair? The reason being is that I'd like to show the numbers for the stair below as it approaches the floor level?

stair capture.JPG

So for the attached image, you've see nos, 14-19 for the stair at the bottom of the image, and tread nos 7 -13 for the stair below.

The other item is the stair direction, I'd like to show an UP arrow to the top of the stair below - not critical because the numbers help with this, but a query none the less.

Any help would be greatly appreciated, even if work arounds...

Sarah