Duct Accessory's and Duct Gapping

[tgolden]

I'm needing to show a temperature sensor in some of my ducts. I download a family from Siemens that was close to what i needed. When I go to place to probe in the duct. The probe is mask out by the duct gap masking. I'm i doing something wrong or is these just something Autodesk hasn't fix yet?

[stimmo520]

Its not an Autodesk problem. Siemens incorrectly created the family, or they did not understand how you would try to use the family. Temperature sensor probe..couldn't that just be a generic annotation? The would not create a gaping issue.