Hello,
When I try to edit my corridor it waterfalls and I cannot edit the stationing in the assemblies tab
Frustrated
|
Hello,
When I try to edit my corridor it waterfalls and I cannot edit the stationing in the assemblies tab
Frustrated
Can you please clarify? Typically a corridor only waterfalls if the limits extend beyond the length of a profile. To correct this if you go to corridor properties you can adjust the stationing there
In the corridor properties, on the parameters tab, back off the stationing by.004 for that region, at the end that has an issue. you can slow click the box and edit the stationing. It happens frequently when the corridor ends in a curve.
It won't make difference in the stationing to the hundredth, but the corridor will not "waterfall".
Hi ,The first issue we are going to look at is the corridor “waterfall.” This is when the corridor runs out of PROFILE data, or vertical design input, but still has corridor to define. Most frequently this means the design profile ended a little before the corridor ending station.