Results 1 to 2 of 2

Thread: Hypoid gear design

  1. 2017-04-18, 04:56 PM #1
    asimbaig201748043
    asimbaig201748043 is offline
    Woo! Hoo! my 1st post
    Join Date
    2017-04
    Posts
    1
    Login to Give a bone
    0

    Default Hypoid gear design

    Hi
    I am using Autodesk Inventor 2014, and couldn't find any option to design a Hypoid gear in gear design tab. Is there any option? please guide.
    Reply With Quote Reply With Quote
  2. 2017-11-01, 07:01 PM #2
    BWMCDOWELL
    BWMCDOWELL is offline
    Member
    Join Date
    2015-07
    Posts
    7
    Login to Give a bone
    0

    Default Re: Hypoid gear design

    I haven't had a need to but I do recall seeing a tutorial on YouTube for Spiral Bevel gears, probably be a good place to start.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Gear Software
    By GABEDRUMMIN942632 in forum AutoLISP
    Replies: 0
    Last Post: 2012-09-21, 05:56 PM
  2. Gear width too big
    By eli_lied in forum Inventor - General
    Replies: 1
    Last Post: 2009-05-29, 01:54 PM
  3. Gear Table
    By inventor.wishlist1738 in forum Inventor Wish List
    Replies: 0
    Last Post: 2009-02-07, 05:47 AM
  4. Gear Design - Create Hubs on Gears
    By inventor.wishlist1738 in forum Inventor Wish List
    Replies: 0
    Last Post: 2008-10-07, 02:19 AM
  5. Gear Design
    By dougsilvi in forum MDT - General
    Replies: 3
    Last Post: 2004-09-07, 03:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules