Does anyone know if there is an easy way to show a flex duct takeoff like this in Revit (see attached pdf) Essentially just a round spigot attached directly to the rectangular main duct?
At present Revit puts in a rectangular cross and then a rect - round duct transition and then the flex, I just want the cross to be a rectangular main section with round brach connectors.
I noticed there is a rectangular to round duct takeoff duct fitting, but I can't seem to get it to work.
Anyone else like to share their thoughts? Otherwise I know it wouldn't be too hard to make my own custom fitting, I just don't want to reinvent the wheel.