if i only have a few cogo points, say 10 that are in a straight line represent existing ground, is it possible and how would you create a profile without creating surface/and or an alignment.
|
if i only have a few cogo points, say 10 that are in a straight line represent existing ground, is it possible and how would you create a profile without creating surface/and or an alignment.
If this what you want I would make my alignment, then make a profile view from that align. then station the points with the el you what then plot sta and el in the profile view. if the profile is long the alternative is. Make a feature line along the points offset this a couple feet then generate a surface.