Results 1 to 4 of 4

Thread: What is current snap angle?

  1. #1
    100 Club
    Join Date
    2016-04
    Location
    California
    Posts
    149
    Login to Give a bone
    0

    Default What is current snap angle?

    Hi guys,
    Is there a command to find out what the current snap angle is. IE not change it but just read it.
    Thanks

  2. #2
    Certifiable AUGI Addict ccowgill's Avatar
    Join Date
    2004-08
    Location
    Iron Station, NC
    Posts
    3,198
    Login to Give a bone
    0

    Default Re: What is current snap angle?


  3. #3
    100 Club
    Join Date
    2016-04
    Location
    California
    Posts
    149
    Login to Give a bone
    0

    Default Re: What is current snap angle?

    Thanks Chris,
    But this command does not tell you what (in my case) someone else has set the snap angle to. I just want to find out what it currently is set to. This way if I change it I can go back to the original setting if required. Is there a technique to see this value?

  4. #4
    Certifiable AUGI Addict ccowgill's Avatar
    Join Date
    2004-08
    Location
    Iron Station, NC
    Posts
    3,198
    Login to Give a bone
    0

    Default Re: What is current snap angle?

    perhaps I do not understand what you are tyring to get. if you type in SNAPANG at the command line and hit enter, in the value that is displayed before you type it shows what the current snapang is. if you type in (getvar "snapang") it returns the vale in radians. so you would need to multipy by 180 and divide by PI to get your degrees. its just easier to type in SNAPANG and then hit escape if you dont want to change it.

Similar Threads

  1. Rotation angle in Properties not to current UCS
    By mtc.139414 in forum AutoCAD General
    Replies: 6
    Last Post: 2018-09-20, 11:06 AM
  2. Snap only to Points in Current View
    By mbickerton in forum AutoCAD General
    Replies: 3
    Last Post: 2007-11-01, 11:23 AM
  3. Snap to current layer only
    By autocad.wishlist1734 in forum AutoCAD Wish List
    Replies: 0
    Last Post: 2006-09-11, 04:46 PM
  4. Rotating pick box when using snap angle...
    By cnash in forum AutoCAD LT - General
    Replies: 3
    Last Post: 2005-11-14, 03:55 PM
  5. Snap angle
    By BCrouse in forum AutoLISP
    Replies: 1
    Last Post: 2005-04-21, 08:25 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •