Using flip commands while maintaining stretch function integrity

[Joe695170]

Hi everyone,

I am trying to create a block that shows three basic views of one product. if you look in the attached DWG you can find the block, and the linear parameter at the top of the largest rectangle will stretch the height of that geometry. I have created a similar stretch command that will stretch the long, skinny geometry to the side of the block in width as well, proportionally to the large geometry (I had to modify the angle offset to 90 to allow for this). I have also added a flip function to allow for the skinny geometry to flip between the smallest geometry.

Unfortunately when you activate the flip action and subsequently try to modify the height of the largest geometry, the skinny geometry stretches in the same direction (90 degrees), which is actually the opposite direction I need it to stretch. If there is any way we could actuate the angle offset for this stretch function as the flip states are activated so that the skinny geometry will always grow/shrink with the large geometry, or if there is some other way I could achieve this action that would be AWESOME. I'm sure there is a simple solution out there I'm just spacing on it.

Thanks in advance.

[havraham2726806]

I solved that
I added the stretch act (90) to be selected in flip action
What do you think

My English is translated please consider