Hi There,
I´m quite new in this forum, so I just hope I ask in the good Segment.
I´m working on a Family Part, where I want to multiply a nested Family in a line. It looks not so complicated and it works as long I do not vant to change the Nested Family Object Type from a Family based Parameter.
Specially:
- I have a Sectional Door, where The Panels are coming from Different Nested Families. (The Base of the Families are the same, so teoreticaly it should work).
- I want to multiply the Sectional panels over each others from a calculated Parameter.
- I change the Nested Family Height and Width from a Parameter as well.
- Until I do not want to change the Type (based on TypeCatalog) of the nested Family, everything is fine, but after the Family just collapsed.
Is there somebody, who can help on me, how it should work?
Before parameter Change:
SectPanels.jpg
after parameter change
SectPanels_afterTypechange.jpg
Attached my Family test (Revit 2016)