Adding another swing to the Dynamic Door that comes with AutoCAD

[dustin692884]

I started with the dynamic door that comes with autocad and just wanted to add a 80d swing to the list of swing options. After i did it, everything looked good until i flipped it AND then changed the opening.

I could not figure it out so i submitted to the client the door without flips and told them to rotate and mirror as needed

but what am i musing

i have attached three files

r00 is the original one the comes with AutoCAD (w/o 80d swing)
r01 is the same as r03 but i deleted the flips in r03 (w 80d swing)

Please let me know