Originally Posted by
paul758804
question 1: when I do a distance on the offset command it only allows me to do inches not feet and inches. how do I change that?
question 2: when I do area say on a 10 by 10 box it should say 100 square feet, but the square footage is not showing up. I do it from point to point to point etc... and it says area 14400.000 and perimeter 480.000 how do I fix that?
question 3: when I hatch something and its wrong, I go to erase the hatch and all the outside lines go too. how do I fix that?
Thank You very much
Paul