I am using ACA 2017
We use spaces to calculate our square footages and then put them into a chart. We have the chart auto populate the total. I have the precision set to 0 but the chart is still reading numbers past the decimal to calculate the total. So if my square footages are 1804 and 1904, it's auto populating the total to 3709. How do I get AutoCAD to only add the numbers listed on the chart?
If I change the precision to .00 it will keep adding past that precision as well. Do I have my settings set up wrong? Any help would be greatly appreciated!
I've attached a pdf of the settings and the chart so you can see it's not adding up properly.