So I found out about Dynamic Blocks and added dynamic features to rotate and move the attributes in my entire block library. Very cool for layouts.

However,

When I run a Data Extraction or Attout every block that has had its dynamic features used to move the attributes loses it's block name in the extraction and attout.

This is a copy/paste from the attout I did on a test drawing:
HANDLE BLOCKNAME ID DMX SOCA LOCATION
'1F3 *U2 21 %% %% %%
'1E1 Robin 100 LED Wash 22 %% %% %%
'1CF Robin 100 LED Wash 23 %% %% %%
'1BD Robin 100 LED Wash 24 %% %% %%
'1AB Robin 100 LED Wash 25 %% %% %%
'199 Robin 100 LED Wash 26 %% %% %%
'176 *U3 10 %% %% %%
'164 Robin 100 LED Wash 11 %% %% %%
'152 Robin 100 LED Wash 12 %% %% %%
'13F Robin 100 LED Wash 3 %% %% %%
'12C Robin 100 LED Wash 2 %% %% %%
'118 *U4 1 %% %% %%

This is 12 identical blocks (Robin 100 LED Wash), I inserted some going the whole process of browsing for the block, some copied with the copy command and some were mirrored.
The only attribute that I have entered data for is ID, the others are the default %%.
I ran several attouts as I added more items and all where good. Then moved the attributes on three blocks. These three blocks are now identified as *U2, *U3 and *U4. If you examine them in the properties window they still have the right name just not in either an attout or dataextraction.

Does anybody have a clue? I don't really want to through the library again adding a "name" attribute to everything...

Rory