A Revit detail line, Solid #6 width is solid until it gets longer than 101' 11". At 102' or longer, it changes to a Center Line Type! When shortened under 102' it returns to a solid line.
Any thoughts?
|
|
Revit Line changes type when it exceeds a given length
A Revit detail line, Solid #6 width is solid until it gets longer than 101' 11". At 102' or longer, it changes to a Center Line Type! When shortened under 102' it returns to a solid line.
Any thoughts?
Re: Revit Line changes type when it exceeds a given length
If you change the pen does that make a difference?
What Revit version/build are you on?
I can draw a 400' long detail line set to continuous and it's fine.
I'd check your line type settings.
Posting Permissions
Reply With Quote