Hi, I have an absolute ripper of a problem. Small but very annoying.
I am using 2019LT and all of my support paths are to my C drive, not a server.
I have 14 custom menu's loaded, however only 1 of them disappears when I re-open CAD.
The menu is still loaded but does not appear, if i change workspace's then the lost menu appears.
I have attempted to load a 'test' menu which also does not remain after closing CAD.
I have removed all menu and only loaded the problem menu and that works and stays put.
(It's almost like the limit of loaded menus is 13)
I thought I might be running out of space for all of the menus.
The menu still didn't stay for a menu named only T (small and still space left over)
Other things to take note of,
My custom.cuix is correctly pathed in the support paths location.
The menu still exists when typing CUIL (load/unload customizations.
My custom.cuix file is not read only.
I have been saving my workspace before closing.
I have completed a full re-install.
Thankyou, I am looking forward to resolving this problem!