Results 1 to 1 of 1

Thread: Get Polyline information from a Dynamic Block

  1. #1
    Member
    Join Date
    2014-10
    Posts
    12
    Login to Give a bone
    0

    Post Get Polyline information from a Dynamic Block

    Hello AUGI Users –

    I’m looking for some help to grab the polyline information from a dynamic block and place that information into an attributed table in the same drawing.

    The dynamic block has 2 stretch parameters. These parameters allow the user to stretch the polyline to the desired width and height. The program should only use the maximum vertical and horizontal lengths of the polyline (‘X’ and ‘Y’). These values would be used to populate the attributed table. The format of those values should be fractional (precision set to 1/32).

    I have attached a sample drawing with both blocks mentioned above.

    Thank you in advanced for your help with this.
    Attached Files Attached Files
    Last edited by r.zinke; 2019-02-06 at 03:42 AM.

Similar Threads

  1. Replies: 2
    Last Post: 2013-06-04, 02:59 AM
  2. Replies: 1
    Last Post: 2012-02-16, 06:58 PM
  3. EMERGENCY!!! - Dynamic Block Information Lost
    By savaytse66 in forum Dynamic Blocks - Technical
    Replies: 1
    Last Post: 2008-06-23, 05:34 PM
  4. controlling table information from a dynamic block
    By james.126519 in forum Dynamic Blocks - Technical
    Replies: 23
    Last Post: 2007-12-04, 04:46 PM
  5. Replies: 4
    Last Post: 2007-01-09, 12:24 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •