I recently posted a question to the forum which was how to construct sidewalks in Revit. The general response I got was to use the floors tool and construct them on my site plan. The problem I am having now is printing. When I switch to my 1st floor plan view the sidewalks are there, because they are really just floors.I tried to use the hide/isolate tool which at first glance works fine, until you want to print. When I print my sheet, the floors are still there. The only way I can turn off the sidewalks is with visibility control; turning off all floors, but this is not acceptable. I need to print the floors inside the building. Any suggestions?