Copied dynamic blocks not dynamic anymore..

[kwong]

Hi all,
I just copied some dynamic blocks in the same drawing & the copied ones don't seem to be dynamic anymore. I say "don't seem to be" because they've lost their "handles" but when I bedit them they still have their parameters. Can anyone explain or help? Thanks.
kwong

[Mike.Perry]

Hi kwong

Please note I have *moved* this thread from the AutoCAD 2006 General Forum to this one as I believe it would be better served here.

Thanks, Mike

Forum Moderator

[Robert.Hall]

I have had the similar issues, still cannot figure out why.

[mark.62793]

I've never seen that one before? Have you tried PURGING your drawing right before dropping in the paste clip?

sorry not much help.

[RobertB]

How did you perform the copy?

[kwong]

Mark: Yes I purged the drawing, also did an audit.

RobertB: 2 ways - one was copy to same drawing and the other was copyclip & pasteclip to another. The first method was OK sometimes, but the second never OK. I ended up inserting fresh blocks to all the drawings in the end.

kwong

[cwade]

I haven't had a problem with either, I just finished using them in a project where I had to do both.