Winder Stair

[BWG]

Can Revit do this? I am sure it can, but I can't seem to get it to work. It keeps telling me that stairs require no more than 2 boundaries?. Everything is closed as far as I can tell.

I have the boundary lines split at the winder part so those two treads are separate on each side, so each run has it own boundary.

[Matt Brennan]

Can you post the file Please?

[BWG]

Can you post the file Please?

Well, I could, but it shouldn't matter because all the stair info will be gone.

[blads]

Winders stairs can be done... although they're very tempermental... still give me grief even now...I haven't done ones quite like yours... but similar (see images)

[SkiSouth]

Draw the stair as a "u" shape, leaving the landing the size you need. Select one of the treads and move the endpoints to where you need them.

[Wes Macaulay]

Bruce, I'm not sure why your winders weren't working, but if it's any consolation, winder stairs are tough. Revit mashes them -- check out the railings on the attached... they're all over the place!

One clue might be where you've broken the boundary lines. You need to do it any time the stringer is changing slope. But I get that boundary message from time to time, so sometimes I just start over again.

[Wes Macaulay]

...the stair attached above parrots the sketch from your screenshot BTW.

[KarinZawrotny-wwa]

We have been using winders quite a bit on one of our projects. We found the simplest way was to draw the boundaries (I always think of that as where the stringer would be)... and then use the riser tool to draw in the risers. The last step is to make sure that the boundaries are 'broken' at the landings or the railings will continue to slope on past them. So far we have not had any problems - but we have also not yet customized the railings. (That's next!).
Hope this helps.

[BWG]

I think it was one of the run lines in the center causing the problem, but I never got a chance to see if it fixed the problem. I tried moving a boundary by clicking and dragging and got the dreaded save as exit program message. It hasn't crashed yet - dreaded hourglass displaying, so I guess I am about to lose the entire file since I will probably have to restart. Seems like 8.1 is a little more buggy than 8.0 was.

[BillyGrey]

"Save As & Exit" will not dump your work!