OCE 9400/AUTOCAD 2006 Major Printing Problems.

[eherrera.84543]

Hi Everyone,
I have been very aggravated with this one and would appreciate anyones help because it would save me some hair. Our office just recently updated to Autocad 2006 and been having serious plotting problems. We have reloaded our autocad with the latest printer driver and are using the same ctb pensettings but have had blocks appear to ghost out in portion of our drawings and have polylines on the same layers and properties print in thick to thin in different segments.

Does anyone have any suggestions on obvious and not so obvious solutions? REALLY APPRECIATE IT.
Thanks,
Erin

[Mike.Perry]

Hi

Have a read of the following couple of posts...

RE: TIF plotting problems

RE: Large Plots

Have a good one, Mike

[eherrera.84543]

Dear Mike,
Thank you for referring me to the other cases. I found some documentation of these ghosting properties under the Oce Heidi driver installation with posted workarounds for oce settings. We're also looking at our firmware which we hadn't considered. For anyone looking at this thread, Oce recommends using the heidi driver downloaded from the Oce site and choosing 'Use disk' rather than using the driver provided by Autocad in the Add-a-plotter wizard. Not fixed yet but feel like I'm getting close>
Thanks again for your help. Mike your the best
Sincerely,
Erin