Good Morning To AUGI Members:

Is there a way to convert Aligned dimensions on a drawing to Rotated dimensions...??...

We receive drawings from a consultant that have both Aligned and Rotated dimensions and I want to isolate the Aligned dimensions and convert them into Rotated dimensions. The reason for this replacement is to allow us to shorten or extend the dimension extension lines without disturbing the alignment (orientation) of the dimension line and text string that will occur on an Aligned dimension if you move either of the original attachment points.

Could this be accomplished with a lisp routine...??

If this is difficult to do can a selection set of just the Aligned dimensions be created with a lisp routine...??

Any assistance with this matter would be appreciated.

Regards,
Vince