Problem with DB of Door in Plant

[mateo]

Someone can help me with this dynamic block of a door in plant?
The problem is in the arch with Action Scale.
I have tried with two Stretch actions, but the arch does not show correctly.
I believe that it might be solved better if the linear parameter of the width of the hollow (wall to wall) was replacing it with the width of the door sheet.
But be interested that the width of the hollow prevails over the width of the door.
Thank you.
Excuse my english.

Mateo.

[Rico]

Someone can help me with this dynamic block of a door in plant?
The problem is in the arch with Action Scale.
I have tried with two Stretch actions, but the arch does not show correctly.
I believe that it might be solved better if the linear parameter of the width of the hollow (wall to wall) was replacing it with the width of the door sheet.
But be interested that the width of the hollow prevails over the width of the door.
Thank you.
Excuse my english.

Mateo.

Sorry we never replied to this mateo .... sometimes posts slip through.

if you never solved this problem, you should try checking out the Dynamic Block Sharing Thread. There's about 4 or 5 different dynamic door blocks that various users (including myself) have posted. It's a bit lengthy so you might have to search for them.

If you don't wanna do that, then try adding a scale parameter to your horizontal linear stretch. But don't forget to also stretch the door leaf as well in a 90 degree angle. it should work fine then.