make sheet sets "collapse" as the default?

[markjnstne]

This is a tiny issue, but has been bugging me for a while. I love the sheet set manager. It's an awesome tool. However, some of the sheet sets I've generated open up "expanded", showing all the sheets in all the subsets. I'd prefer to have them "collapsed" as the default.

Does anyone know how to change this? I've been looking, but haven't found it yet. I think the issue may be caused when the sheet set is first generated (and then saved for the first time maybe?). If so, there should be a way to alter the default. I'm hoping!

Thanks for your time, everyone.

Mark Johnstone
CAD Manager
SunCor Development

[Opie]

Mark,

Do you have your sheets in just the main Sheet List? Or do you have them in Subsets? I found that the subsets that are not being references are collapsed on the initial open.

HTH

[markjnstne]

I don't have any sheets off the main trunk...all of my sheets are in one of several subsets. The subsets always open up initially (at least on some of my sheet sets) as "expanded". My first order of business when dealing with those offending sheet sets is to collapse all of the subsets so I can see them all (the subsets). It's a little tiring after a while.

[drzaius]

I don't have any sheets off the main trunk...all of my sheets are in one of several subsets. The subsets always open up initially (at least on some of my sheet sets) as "expanded". My first order of business when dealing with those offending sheet sets is to collapse all of the subsets so I can see them all (the subsets). It's a little tiring after a while.

I was also looking for an answer to this. At least you can collapse all subsets to start with by selecting a sheet then right-clicking on the scroll bar and selecting "collapse all"