I have a wall where I have edited the wall profile to achieve an arch. However, I cannot seem to attach a profile to the top. The profile is supposed to match the profile on the other walls. I'm not sure what I doing wrong.
Thanks.
|
I have a wall where I have edited the wall profile to achieve an arch. However, I cannot seem to attach a profile to the top. The profile is supposed to match the profile on the other walls. I'm not sure what I doing wrong.
Thanks.
Use an in-place family sweep to get your desired result.
Also, you will probably need a void at either end to "cut off" the sweep
Thank you. I got brain lock on this and was trying to create a family, without doing it in-place and I was making things difficult.
Thanks.