Originally Posted by
briamor
Hello:
I'm trying to teach myself AutoCAD. I'm doing AUGI, and every tutorial that I can find.
So I figured I'd give myself a little "test" and started trying to make a "hypothetical" entertainment center. I had just started when I ran into something I can't seem to figure out how to do. Now lets see if I can explain it.
OK so I have a box .....
Looking down at it from the top, you can see that the 4 corners have a round-over (rounded) (Fillet-ed) edge. R=.187
but... if you look at it from the side view...
I want it to have a chamfered edge going all around the top of the box.
How can I have the vertical corners rounded, but the horizontal corners beveled/chamfered on the same box?
I've tried everything I can think of (but evidently there is one thing I didn't think of...right?)
making them all lines, polylines, keeping them as a 3D Box, 1st beveling them as a 2D thing, then trying the roundovers after extrustioning it, etc.... I can't seem to figure out this little step.
any suggestions...
thanks
Bruce