Results 1 to 2 of 2

Thread: Design Center Error and Malfunction when trying to use Blocks

  1. 2006-04-11, 01:30 PM #1
    billuky
    billuky is offline
    Member
    Join Date
    2006-04
    Posts
    2

    Default Design Center Error and Malfunction when trying to use Blocks

    When I access Design Center & click on 'blocks', I get an error: "the specified module could not be found". There are no blocks shown, thus Design Center is not usable. Any ideas?
    Reply With Quote Reply With Quote
  2. 2006-04-11, 08:42 PM #2
    Mike.Perry
    Mike.Perry is offline
    Administrator Mike.Perry's Avatar
    Join Date
    2001-03
    Posts
    13,499

    Question Re: Design Center Error and Malfunction when trying to use Blocks

    Hi

    Has this issue / problem always been there, or has it just recently started ?

    +

    Maybe try this post ( RE: Design Center Freezing AutoCAD LT2006 )...

    +

    Have you tried a Repair Install ?

    Have a good one, Mike
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Importing Title Blocks from Design Center
    By Michael.R.Janicki in forum AutoCAD General
    Replies: 3
    Last Post: 2012-02-17, 07:57 PM
  2. Inserting Blocks from the Design Center
    By lem in forum AutoCAD General
    Replies: 3
    Last Post: 2005-02-06, 03:40 PM
  3. Design Center blocks not scaling properly
    By mjsregister in forum ACA General
    Replies: 3
    Last Post: 2004-06-14, 08:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules