Results 1 to 4 of 4

Thread: Switch back and forth between Isometric and Rectangular Snaps

  1. #1
    Member
    Join Date
    2006-05
    Posts
    8
    Login to Give a bone
    0

    Question Switch back and forth between Isometric and Rectangular Snaps

    Our facility rarely uses 3D, so we use the LT version. On occasion I like to make a drawing jump out so I'll do an isometric drawing. There is an issue I wish someone could help with, switching back and forth from isometric to rectangular snaps. There just seems to be to many steps. Is there any way to shorten this up?

  2. #2
    Administrator Opie's Avatar
    Join Date
    2002-01
    Location
    jUSt Here (a lot)
    Posts
    9,096
    Login to Give a bone
    0

    Default Re: Switch back and forth between Isometric and Rectangular Snaps

    Please note I have *moved* this thread from the New Forum Users Forum to this one as I believe it would be better served here.

    Below snippet is from the small print on the Forum General page -

    <snip>
    New to the Forums? This is the place to experiment with the posting editor and learn how to interact with our forums. Please experiment here with forum features and commands.
    </snip>

    Thanks,

    Richard
    Forum Moderator
    If you have a technical question, please find the appropriate forum and ask it there.
    You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
    jUSt

  3. #3
    Certified AUGI Addict jaberwok's Avatar
    Join Date
    2000-12
    Location
    0,0,0 The Origin
    Posts
    8,570
    Login to Give a bone
    0

    Default Re: Switch back and forth between Isometric and Rectangular Snaps

    snap [enter[
    s [enter]
    i [enter]
    [enter] {or "value" [enter]]

    snap [enter[
    s [enter]
    s [enter]
    [enter] {or "value" [enter]]

    You could put each on a toolbar button or in a script.

  4. #4
    Member
    Join Date
    2006-05
    Posts
    8
    Login to Give a bone
    0

    Default Re: Switch back and forth between Isometric and Rectangular Snaps

    Thanks for the information, I've got a lot to learn.
    I've never used a forum so this has also been a challenge getting around and finding information. Thanks again.

Similar Threads

  1. Way to switch back to Home tab?
    By kristy in forum AutoCAD General
    Replies: 4
    Last Post: 2016-08-16, 05:01 PM
  2. 2015: Sweeps snaps back to a length I dont want.
    By Bluefairy in forum Revit Architecture - General
    Replies: 0
    Last Post: 2014-07-22, 05:40 PM
  3. labels versus tags. can't switch back?
    By Maverick91 in forum AutoCAD Civil 3D - Alignments
    Replies: 4
    Last Post: 2012-04-29, 03:33 AM
  4. how to switch back from MEP to Autocad
    By LynNV in forum AMEP General
    Replies: 1
    Last Post: 2010-09-15, 11:41 PM
  5. Toggle to Switch Between Iso and Rectangular Snaps.
    By autocad.wishlist1734 in forum AutoCAD Wish List
    Replies: 0
    Last Post: 2008-10-11, 09:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •