Bloody gutters won't join!!

[aaronwsmith]

I have a standard hip roof, well not quite standard because i have made it in a couple of separate pieces. But still i have joined the geometry of the pieces, added fascia, but when i go to add the gutter around where the corner of the two pieces where the gutter should also be forming a corner, this does not happen! they just have open ends! why???
please help.

[mtogni]

Try to make the gutter in a single process, I mean pick every side continously. This could solve the problem.
Also, be care the level must be the same!
Hope this helps.

[patricks]

Check the blue handles at the ends of the gutters and make sure they're both at the same location for each gutter piece.

Now if you're choosing a fascia sweep as the edge to host your gutters, and the fascias don't exactly trim together at a corner, then the gutter won't either, and you'll have to manually pull the ends of the gutter together to miter the corners.

[Hexdown]

Same problem here.......i'm sure they were OK earlier in the day!!.... cant get those internals too join.

Also anyone no the best way to fit a stop end??

Capture.JPG