Lables not functioning Properly

[Aquaserpent]

To All;

I have tried to setup a label to identify the Alignment Name, I would like this label to be displayed under the alignment in plan view. I have set it under labels and it doesn't show up, I tried it under line and it still doesn't show up. When I set it up under major stations it shows up and is displayed under the line like I want it, the problem is that it is under "every" major station. That is too many labels, I was hoping for just a few. Does anyone have any other ideas?

[eckdahlrd]

Here's a couple options, you could do it as a "line" style, then use the add labels, single segment, and just put them in where you want them to appear.

A more "automatic" method is to use the major station label one, but give it a larger interval so it happens once every 1000 feet or so.

I just realized how long ago you posted, hopefully you've gotten a solution by now.

[Aquaserpent]

I did figure this out quite sometime ago. I have the label displaying every 300'.

[dmo1205342273]

I have a question about Alignment Label Styles. In Land Desktop one could place tick marks exactly where the station in question occured. I can't seem to find it in the styles for Civil 3D. We no longer have Land Desktop so I can't go back to check anything. Any Tips/Suggestions? Also of interest would be tips for the dragged state for the Alignment Labels. Thanks in advance.

Nevermind Thanks

[sinc]

The tick marks are components in your station labels.

In Toolspace, "Settings" tab, find Alignment->Label Styles->Station. In this section are Major and Minor Station label styles. Go into the label style of your choice, and create (or turn on) a "Tick" component. You do this on the "Layout" tab of the Label Style Composer.