Trim :Selecting entites on the Screen without Selection.

[balubharadwaj]

The Following procedure is useful when you need to trim a lot of in-between entities in a random fashion.

In the Trim Command during “select objects” prompt just give a blank entry
All the entities on the screen is selected for trimming

During trimming process even if u pan the screen the objects seen on the screen is will
Become active selection set.

[Opie]

Thanks for sharing. I agree, it's a good tip.

[jmctamney]

The Following procedure is useful when you need to trim a lot of in-between entities in a random fashion.

In the Trim Command during “select objects” prompt just give a blank entry
All the entities on the screen is selected for trimming

During trimming process even if u pan the screen the objects seen on the screen is will
Become active selection set.

Becarefull if you have projection turned on. Splines will project out hundreds of lines and you'll be trimming forever