Object Enabler

[savage943]

Whenever I open a file, I get a Proxy Info popup. However, when I use Object Enabler, it doesn't find anything. It has to do with AcMechDwgViewMgmt, AcmeServices, AmiServices, and DesignerServices. Consequntly, not everything shows up in the drawings. Have tried all 3 radio buttons to o avail.

[mjfarrell]

What application is generating the Proxies?

Peep at these:

http://usa.autodesk.com/adsk/servlet...linkID=2475323

http://usa.autodesk.com/adsk/servlet...linkID=2475161

http://usa.autodesk.com/adsk/servlet...linkID=2476059


Try the last one first>

[savage943]

I am using AutoCAD 2005. Have tried to open dwgs created with AutoCAD 2004, and AutoCAD R14 and get same. Tried the Object Enabler website and says that there are no enablers for this.

[Mike.Perry]

Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS68953 - Cannot view mechanical objects in AutoCAD® even though Object Enabler is applied

Have a good one, Mike

[savage943]

Thank you for the response. Will give that a try. Hope the people on the other end will do so. Also hope that Autodesk comes up with an enabler for this problem soon.....