wall elevation changes

[tkilbane]

I am having trouble getting walls on different elevations to clean up. Usually I can apply an endcap to fit the situation except where wall are perpendicular. An endcap which opens up one wall provides the first step but I do not know how to clear a portion of the middle of a wall.

[mjfarrell]

http://usa.autodesk.com/adsk/servlet...linkID=2476059

[eric]

http://usa.autodesk.com/adsk/servlet...linkID=2476059

The info in the link works, but I find it easier to right-click on the wall, select Floor/Roof line, Modify Floor Line, then O for Offset. Positive values increase the wall bottom elevation, negative values do the opposite. This way all components change at once. As the link says, baselines must match Z for walls to clean up.

HTH

Eric A Good AIA