Outlook caused TrueView to configure each time

[Ron_M]

Every time I launch Outlook 2003, a DWG TrueView 2009 window pops up saying "Please wait while Windows configures DWG TrueView 2009."

It takes a while for the configuration to finish and then Outlook appears to run normally.

However, it's very annoying and obviously not right. Any ideas?

[RobertB]

Your MSI is messed up. This issue can happen in lots of different installations. Check on Microsoft's web site for more details.

[Ron_M]

RobertB - Can I probe your brain a little deeper? Looking up msi (Microsoft Installation) files casts to wide a net. Don't know where to start.

Some more info from my end. I'm on a company provided laptop where a disk image was used to set it up. Still don't understand how launching Outlook causes a DWG TrueView installation to launch each time?

Thanks in advance.

[rkmcswain]

Looking up msi (Microsoft Installation) files casts to wide a net. Don't know where to start.

Take a look at this...
http://www.winhelponline.com/article...-failures.html

[RobertB]

Take a look at this...
http://www.winhelponline.com/article...-failures.html

R.K., that was a good post but might be too techie. I've linked an alternative article.

Microsoft TechNet article

[Ron_M]

Thanks all!