Plotting from a Model

[lin.harris]

Hi! All! I'm having a problem with plotting a drawing to which, I've made changes. The model that is shown that I've made the actual changes to is fine. The model that is printing is a 2" square with a huge #78 in the drawing. I don't understand how this model was developed?

Help! This is for a project and I'm under a little pressure.

Thanks in advance for your help!

Lin

[arcadia_x27]

Sounds like maybe you need to refresh your xref's? or it could be a scaling problem in a viewport. Without a better explanation its hard to pinpoint your problem What version of Autocad are you using? Caould you possibly post the drawing or even a screen shot so we could see whats going on

[lin.harris]

I appreciate you getting back to me on this problem. Unfortunately, I don't know how to e-mail the image to you. It may be a scaling issue. The original drawing was plotted on a 24"x 30" parameter. And it printed just fine. But, after I made the changes it was this 2" square image. And regardless of what demensions I set the parameters it always comes out the same 2" square size. I hope this is a clearer explanation. Thanks!

Lin

P.S. I'm using AutoCAD LT

[Mike.Perry]

Unfortunately, I don't know how to e-mail the image to you.

Hi

Attach the DWG file directly to a post within the Forums.

Check out the FAQ page -

What Are Attachments?

Have a good one, Mike