Results 1 to 2 of 2

Thread: Steel stair stringers and hand rails

  1. #1
    Certified AUGI Addict patricks's Avatar
    Join Date
    2004-06
    Location
    Memphis TN area
    Posts
    7,048
    Login to Give a bone
    0

    Default Steel stair stringers and hand rails

    I have a profile set up as a railing object for my C-channel stringers along my concrete pan stairs. Now is there a way to get my hand rail balusters to trim to the slope of that stringer, as the balusters will be welded to the top of that channel flange?

  2. #2
    AUGI Addict
    Join Date
    2001-07
    Location
    Phoenix, AZ
    Posts
    1,003
    Login to Give a bone
    0

    Default Re: Steel stair stringers and hand rails

    You could make a custom baluster that slopes to match the stringer. I don't know if you can get one baluster to work in all locations but, as a last resort, you could make a series of them with differing angles and swap out as needed with new rail types.

Similar Threads

  1. Dimensioning circular hand rails in plan
    By patricks in forum Revit Architecture - General
    Replies: 3
    Last Post: 2010-04-17, 09:32 PM
  2. Hand rails returns at the end
    By AUGI Strangelove in forum Revit Architecture - General
    Replies: 7
    Last Post: 2008-12-12, 07:48 PM
  3. the question about Stair Rails
    By luongngocthi in forum ACA General
    Replies: 1
    Last Post: 2006-04-08, 09:41 AM
  4. Stair stringers
    By Tom Weir in forum Revit Structure - General
    Replies: 3
    Last Post: 2005-11-10, 05:34 PM
  5. Stair Stringers Visibility
    By JTF in forum Revit Architecture - General
    Replies: 5
    Last Post: 2003-05-08, 05:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •