I'm working in ADT2006.
I'm designing a 3-story building in ADT, and have created the building's shell separate from each level (and each level's interior information), in order for the shell to look correct when generating exterior elevations.
I've adjusted the 1st level's display configuration just fine (through the display manager) to only display the exterior wall relevant to the 1st level. That is, the floor plan is cut at 3'6" and only displays exterior wall information +/- 5'-0" above and below the cut plane. However, I can't get the 2nd and 3rd floors to display properly, even though the exterior walls run past the those floor levels, and the 3'6" cut plane should be the same and relative to each floor level (as determined by the project levels setup on project navigator). I also made sure to click on "Section AEC Object by Display Range..." in display manager under "sets" and then "plan".
Any ideas?
Thanks