Has anyone had trouble with the "view reference" tag part of the Matchline. I have followed the instructions from Revit Help and I cannot get the tag to display the sheet number and Name - it on says "Ref". Does anyone have any suggestions.
|
Has anyone had trouble with the "view reference" tag part of the Matchline. I have followed the instructions from Revit Help and I cannot get the tag to display the sheet number and Name - it on says "Ref". Does anyone have any suggestions.
Did you put them on a sheet ?
Are you using the OOTB tag ?
The 2 dependant views are on a sheet - the overall is not (i have tried putting this on a sheet and it still does not work. I am using the view reference under the match line - not sure what the OOTB tag is?
then yes the view reference is from out of the box...
Did you make sure the view reference tag was pointing to the correct view?
Last edited by jcoe; 2007-08-21 at 07:47 PM. Reason: Updated Image File
yes - it always says ref no matter which view I use
Make sure you loaded the View Reference Tag in your project. And update the View Referecnce Tag in its Element properties. See Attached image for further clarification.
Hope this helps,
Thank you so much - I thought I loaded the tag - the catagory does not show up on loaded tags. I guess I need to check other locations ie the family list and the type.
OK. According to help and my many trials, one can not place a view reference in a plan that references a plan which IS NOT dependent. Correct?
Typically, we have a view pulled to a sheet which shows the entire plan (let's say 1/16" scale or smaller) then plans broken up across multiple sheets (let's say 1/8" scale or larger). Therefore the enlarged broken plans can not be dependent of the overall plans. Correct? However, I would still like to reference the plans from the overall plan. Do I need to make callouts to make this happen? In an attempt to do that, I notice that it locks me down to "Floor Plan." This means that I MUST have the same Callout Head for all. Boooooo! You can also not remove the leader and region easily. double boooooo!
*Sigh* Why can't we just add the "reference other view" checkbox like we have in every other view callout/ reference?