LDT 2006 - P&P sheets not aligning correctly with alignment

[mom of 3]

I'm currently trying to set up my P&P sheets with a 20 scale sheet style. I have set all my settings, edited my sheet layout, generated my sheet with the correct series, but for some reason, even after I entered where the start station was, it insists on setting my sheet up starting somewhere in the middle of my alignment. is there something else that I missed?
oh yeah - 2006 with LDT 2006

[dfarris75]

I can't think of anything off the top of my head, but it seems like I have had this issue once in the past. Care to upload the file(s) in question for analysis?

[mom of 3]

I found out the problem after I posted this. I apparently wasn't given all the steps I'd needed to take, that's why my P&P sheet kept starting near the middle of my alignment.
after I went through all the steps of setting up sheets styles, adjusting my vports, then I had to generate my sheets, THEN (this was the step left out for me) I had to load the sheets. that was where the problem lay. when I generated my sheets, the program generated all of them, but just showed me the ending sheet. I then deleted that layout & loaded the sheets, it gave me all 5 of my sheets.

I don't know if that is the same type of problem you're having, but that is the solution to mine. I hope that helps you a little!