Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Annotation - Weld symbol

  1. 2011-12-02, 06:25 PM #21
    clshade
    clshade is offline
    I could stop if I wanted to clshade's Avatar
    Join Date
    2009-01
    Location
    B5
    Posts
    478

    Default Re: Annotation - Weld symbol

    Methinks you found that over at the Autodesk Dynamic Block Forum where the Multi-Vis-State Lisp has been run to make this.
    Charles Shade LT 2013
    www.cshadedesign.com
    Reply With Quote Reply With Quote
  2. 2012-01-03, 08:06 PM #22
    tiffany.amorgan
    tiffany.amorgan is offline
    Active Member
    Join Date
    2006-08
    Location
    Fayetteville, AR
    Posts
    92

    Default Re: Annotation - Weld symbol

    I think I can make some great improvements to my symbol by looking at the one nimrodisease posted, nice. Thanks for sharing!
    Reply With Quote Reply With Quote
  3. 2012-08-15, 01:23 PM #23
    wrartes
    wrartes is offline
    Active Member
    Join Date
    2002-11
    Posts
    59

    Default Re: Annotation - Weld symbol

    how I can split the arrow to have 2 segments
    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« Previous Thread | Next Thread »

Similar Threads

  1. New Weld Symbol
    By djn in forum Revit Structure - Families
    Replies: 13
    Last Post: 2013-04-16, 09:56 PM
  2. Weld symbol gap
    By mattw in forum Revit Structure - General
    Replies: 1
    Last Post: 2010-07-26, 02:02 PM
  3. Help with weld symbol
    By REVIT_MONKEY in forum Revit Structure - Families
    Replies: 4
    Last Post: 2010-05-06, 09:49 PM
  4. Weld Symbol
    By David van Erk in forum AutoLISP
    Replies: 24
    Last Post: 2009-10-10, 06:12 PM
  5. Weld Symbol - Bottom Contour Symbol
    By kcooper.190440 in forum Revit Structure - Families
    Replies: 4
    Last Post: 2008-10-07, 07:21 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules