Results 1 to 6 of 6

Thread: Duct section visibility

  1. #1
    Member
    Join Date
    2007-05
    Posts
    6
    Login to Give a bone
    0

    Default Duct section visibility

    I'm working on a HVAC layout in Revit MEP 2008. Through some bungled settings adjustment, the ducts no longer appear in section (when they are perpendicular to the section cut). They do appear in elevation. I've checked the visibility settings, view properties, etc. but can't find anything that would turn off just the section cuts for the ductwork. Anyone else have this problem?

  2. #2
    Member
    Join Date
    2006-09
    Location
    Western PA
    Posts
    17
    Login to Give a bone
    0

    Default Re: Duct section visibility

    BUMP

    MEP in my office is having this problem too and I'm searching the forum for probable answers. Anyone else run into this? And better yet, anyone else solved it?

    -Emily

  3. #3
    All AUGI, all the time mwiggins121466's Avatar
    Join Date
    2006-09
    Posts
    576
    Login to Give a bone
    0

    Default Re: Duct section visibility

    Check what the detail level is set at. This happened to me.
    Margaret Wiggins
    Revit MEP 2006 and Greater
    Electrical Designer
    Detroit, Michigan
    wigginsm@yahoo.com

  4. #4
    Member
    Join Date
    2006-09
    Location
    Western PA
    Posts
    17
    Login to Give a bone
    0

    Default Re: Duct section visibility

    Detail level has been verified with no change in the duct visibility...

    Anyone else?

  5. #5
    Revit MEP Moderator mjdanowski's Avatar
    Join Date
    2007-03
    Posts
    890
    Login to Give a bone
    0

    Default Re: Duct section visibility

    I only get that when the detail level is set to coarse, like mwiggins said.
    Matthew Danowski, PE, LEED AP BD+C
    Project Electrical Engineer
    Baltimore, MD

  6. #6
    AUGI Addict truevis's Avatar
    Join Date
    2004-07
    Location
    Massachusetts, USA
    Posts
    1,191
    Login to Give a bone
    0

    Default Re: Duct section visibility

    When I get something like that, the first thing I usually try is to Apply View Template of a good view to the naughty view.

Similar Threads

  1. 2015: Duct Visibility Settings
    By slovenc0417 in forum Revit MEP - General
    Replies: 1
    Last Post: 2015-01-05, 03:29 PM
  2. Duct Lining Visibility
    By fduraes in forum Revit MEP - General
    Replies: 2
    Last Post: 2014-03-12, 08:28 AM
  3. 2013: Levels and Duct Visibility Issue
    By rdooley944157 in forum Revit MEP - General
    Replies: 5
    Last Post: 2013-01-04, 11:59 PM
  4. How to show duct filled cross when cutting section thur duct?
    By wboyanton in forum Revit MEP - General
    Replies: 1
    Last Post: 2009-07-14, 01:37 AM
  5. Round Duct Visibility in Section View
    By sernspiker in forum Revit MEP - General
    Replies: 8
    Last Post: 2008-11-21, 05:15 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •