I have posted this with the subscription team at autodesk.
I am awaiting info from them.
In the mean time does anyone else have the same issue?
I am working in ABS2007 (sp1).
Issue:
I am working in ABS 2007 (sp1). I have tried this on both the ootb and our customized (sys def's and template) version of abs.
When ever a duct is running underneath a transition it may or may not create the haloed lines. Here's when I've found it will hide: round to rect transition, oval to rect trans, and oval to oval trans. When I have found it will NOT hide: rect to rect trans and round to round trans.
Interesting point: if you take everything and rotate it 90degrees, the ducts will then halo out underneath the transitions.
I do not think it is my system definitions (I have tried using different duct systems and that did not seem to affect it).
I have attached a drawing based off of my template that shows this issue.
We have several pretty far along drawings that have this occurring in them and we need to get this resolved ASAP.
Thank you to anyone with some input on this.