Results 1 to 2 of 2

Thread: OTRACK stop working in 3d

  1. #1
    Member
    Join Date
    2004-09
    Posts
    2
    Login to Give a bone
    0

    Unhappy OTRACK stop working in 3d

    OTRACK works fine in 2d, stooped working in 3d. 3dpoly does not follow other lines directions. Extend it's stop working properly too.
    After snapping to endpoint, it shows that it is extending, but extensions are happening in X & Y coordinates.
    Anybody had this problem???
    Spend 2 days finding a solution, can not find anything.

  2. #2
    Member
    Join Date
    2008-10
    Location
    Sacramento, CA
    Posts
    3
    Login to Give a bone
    0

    Default Re: OTRACK stop working in 3d

    The newer versions require you to rotate the ucs when switching to a 3D view because it will only allow drawing on the x,y plane. When you switch to the left side view, for example, you will have to change the world ucs to left side. Hope this works for you.

Similar Threads

  1. Extension, OTRACK, TT not working
    By melanie.santer in forum AutoCAD General
    Replies: 10
    Last Post: 2013-12-27, 09:25 PM
  2. Fields in tables stop working
    By cwjean76 in forum AutoCAD Tables
    Replies: 4
    Last Post: 2008-01-22, 04:51 PM
  3. Dynamic Blocks stop working
    By dduggins in forum AutoCAD General
    Replies: 6
    Last Post: 2007-10-10, 02:19 AM
  4. OTRACK stop working in 3d (in AutoCAD 2008)
    By rvitkauskas in forum AutoCAD 3D (2007 and above)
    Replies: 0
    Last Post: 2007-08-14, 05:26 PM
  5. Commands stop working
    By ccowgill in forum AutoCAD General
    Replies: 3
    Last Post: 2006-03-23, 01:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •